How can you connect “eduroam” Wi-Fi with Raspberry Pi ?

When you try to connect “eduroam” wi-fi network you will probably  face a set of peblems . Even if you try to click on “eduroam” wi-fi network at the right upper side on the raspberry pi display screen, you are not able to click because the raspberry pi doesn’t allow you to connect to networks that have TTLA security.

The Solution of issue has several steps, but this post will be short and you are going to solve your problem just in 2 steps.

First of all , prepare your “eduroam” user name and password. User names could be an email address (” yourname@your_university.your_uni_country” ) or a nick name. After that we have to enter data into the raspberry pi, ”wpa_supplicant.conf ” file .

To access “wpa_supplicant"file location push ctrl+alt+t keyboard combination and write the terminal on

sudo nano/etc/wpa_supplicant/wpa_supplicant.conf

Add this script into the wpa_supplicant.conf file and then press “ctrl+x” you will see a warning “would you like to save your changes” press the “y” button and then “enter”.

network={
ssid="eduroam"
scan_ssid=1
key_mgmt=WPA-EAP
eap=PEAP
identity="your_username"
password="your_password"
phase1="peaplabel=0"
phase2="auth=MSCHAPV2"

}

We should activate all changes that we completed above , consequently, open the terminal again and write that sudo wpa_supplicant -i wlan0 -c /etc/wpa_supplicant/wpa_supplicant.conf

Check your connection with “iwconfig” command. If you noticed packet data transmission as mentioned below , you did it. Congratulations !

2 hakkında “How can you connect “eduroam” Wi-Fi with Raspberry Pi ?” görüş

  1. Hi there, You have done a great job. I’ll definitely digg it and personally recommend to my
    friends. I am confident they will be benefited from this
    web site.

Bir cevap yazın

E-posta hesabınız yayımlanmayacak. Gerekli alanlar * ile işaretlenmişlerdir